Active long pulse shaping technique of pulsed CO2 laser using multi-pulse discharge control

We describe the pulse forming of pulsed CO₂ laser using multi-pulse superposition technique. Various pulse shapes, high duty cycle pulse forming network (PFN) are constructed by time sequence. This study shows a technology that makes it possible to make various long pulse shapes by activating SCRs of three PFN modules consecutively at a desirable delay time with the aid of a PIC one-chip microprocessor. The power supply for this experiment consists of three PFN modules. Each PFN module uses a capacitor, a pulse forming inductor, a SCR, a high voltage pulse transformer, and a bridge rectifier on each transformer secondary. The PFN modules operate at low voltage by driving the primary of HV pulse transformer. The secondary of the transformer has a full-wave rectifier, which passes the pulse energy to the load in a continuous sequence.We investigated various long pulse shapes as different trigger time intervals of SCRs among three PFN modules. As a result, we could obtain laser beam with various pulse shapes and durations from about 250 to 1000 μs.     

光纤光栅激光器激射波长的研究

一般认为，用光纤光栅作选频元件的光纤激光器，激射波长与光纤光栅中心反射波长一致，本文报道了不同的实验研究结果。通过细致的实验研究，发现光纤光栅激光器激射波长相对于光纤光栅中心反射波长有一定的偏移。激射波长可以出现在光栅中心反射波长的长波端，也可以出现在其短波端。对不同腔结构的掺镱、掺铒光纤光栅激光器的深入研究证明，谐振腔的各向异性对激光器的激射波长偏移起到决定性的作用，波长最大偏移量主要受限于光纤光栅的反射带宽。通过激光腔内的偏振控制器改变谐振腔的各向异性，可以在光纤光栅的反射带宽内控制激射波长的位置。     

Polytetrafluoroethylene and metal structure convective-flow CO laser

A convective flow CO laser composed of polytetrafluoroethylene discharge tubes, nickel–chromium steel components, a cupric heat exchanger and other components is described. Operating in liquid nitrogen condition, output power of 60 W has been obtained from a non-selective cavity.     

Matrix perturbation theory for driven three‐level systems with damping

We investigate the dynamics of the Λ system driven by two resonant laser fields in presence of dissipation for coupling strengths where the rotating‐wave approximation starts to break down. This regime is characterised by Rabi frequencies being approximately equal or smaller than the field frequencies. A systematic procedure to obtain an expansion for the solution of the Bloch evolution equations of the system is presented. The lowest contribution results to be the well‐known rotating‐wave approximation. The method is based on a semi‐classical treatment of the problem, and its predictions are interpreted fully quantum mechanically. The theory is illustrated by a detailed study of the disappearance of coherent population trapping as the intensities of the fields increase.     

电子束流品质对自由电子激光小信号增益影响的计算

对电子束有一定初始能量分散或角度分散时的自由电子激光小信号增益用较简便的方法进行了分析计算,并给出了一个渐近公式,结果与用计算机模拟解自由电子激光微分方程组得到的结果一致。     

New FIR laser lines and frequency measurements for optically pumped CD3OH

Twenty new cw FIR laser lines in CD₃OH, optically pumped by a CO₂ laser, are reported. The frequencies of 39 of the stronger laser lines were measured relative to stabilized CO₂ lasers with a fractional uncertainty, as determined by the reproducibility of the FIR frequency itself, of 2 parts in 10⁷.Contribution of the U.S. Government, not subject to copyright.     

LOCAL WELL-POSEDNESS AND ILL-POSEDNESS ON THE EQUATION OF TYPE □u = uk((e)u)α

This paper undertakes a systematic treatment of the low regularity local wellposedness and ill-posedness theory in Hs andHs for semilinear wave equations with polynomial nonlinearity in u and (e)u. This ill-posed result concerns the focusing type equations with nonlinearity on u and (e)tu.     

Laser-induced damage of Ta2O5/SiO2 narrow-band interference filters under different 1064 nm Nd:YAG laser modes

The laser-induced damage (LID) behavior of narrow-band interference filters was investigated with a Nd:YAG laser at 1064 nm under single-pulse mode and free-running mode. The absorption measurement of such coatings was performed with surface thermal lensing (STL) technique. The damage morphologies under the two different laser modes were also studied in detail. It was found that all the filters exhibited a pass-band-center-dependent absorption and laser-induced damage threshold (LIDT) behavior, but the damage morphologies were diverse. The explanation was given with the analysis of the electric field distribution and the operational behavior of the irradiation laser.     

The Analysis and Improving of the Microwave Exciter in the Lower Hybrid Wave System

When we carry out lower hybrid wave heating and current driving plasma experiment at tokamak, we need mega-watt order of microwave power. The microwave signal at frequency of 2450 MHz is generated by a microwave exciter. According to the experiment＇s demands, the microwave exciter must provide output power of 1.5～ 2. 5 W with stabilized frequency and amplitude tobe used as the klystron input. Being amplified by the klystron, the microwave signal is transmitted through the transmitting system to the antenna and is emitted into the HL-2A tokamak. So we can see that the microwave exciter＇s function is very important to the lower hybrid wave heating and current driving plasma experiment.